Temperature sensor of the condenser

Temperature Sensor of the Condenser is an ice maker replacement part identified by part number 1851700401. It’s intended for service and repair when the original component is worn, damaged, or missing. Use the part number on your machine or old component to confirm you’re ordering the correct item. By reporting temperature changes during operation, this sensor helps the ice maker maintain stable cycling and consistent ice production. When a sensor drifts out of range or fails open/short, you may see erratic cycling, premature shutdowns, or inconsistent ice thickness. Technicians typically inspect the sensor lead and connector for damage, verify secure mounting, and confirm the control is receiving a reasonable signal. Replacing the part can bring the system back to predictable operation and help prevent repeat call-backs. Match part number {pn} to the original component before ordering, and route the lead the same way to avoid pinched wires. Before closing panels, double-check that fasteners are snug and that nearby lines or wires won’t rub during operation. A careful inspection of adjacent parts can help catch secondary issues that may have contributed to the failure. When possible, run the ice maker long enough to observe at least one complete cycle after the repair. Before closing panels, double-check that fasteners are snug and that nearby lines or wires won’t rub during operation. When possible, run the ice maker long enough to observe at least one complete cycle after the repair. If the symptom is intermittent, pay close attention to connectors, mounting points, and any signs of vibration-related wear. If the symptom is intermittent, pay close attention to connectors, mounting points, and any signs of vibration-related wear. Before closing panels, double-check that fasteners are snug and that nearby lines or wires won’t rub during operation.