KIT FLAKER CONTROL

If you’re sourcing the correct replacement, match part A37750-022 to the kit flaker control. If the machine has multiple production revisions, confirm the unit tag and the original part markings before purchase. As a control board, this part is used to restore control logic and outputs that coordinate the machine’s sequence. Service calls involving this part type often mention outputs not switching, no power response, and stuck cycle. In repairs, replacement is considered when inspection and testing confirm the fault is tied to this component. After installation, run a short test cycle and check for stable operation, leaks, vibration noise, and any recurring fault symptoms. Disconnect power before service, document the original layout with a photo, and reinstall so nothing pinches, rubs, or binds. Replacing the correct component helps restore predictable operation and reduces repeat service calls when the diagnosis is accurate. Good troubleshooting includes matching the part number, checking the installation area, and confirming the failure is not caused by a related component. Control board replacement is normally done after verifying inputs/outputs and confirming external loads or sensors are not causing the fault. Once the failed part is confirmed and replaced, cycle behavior should normalize and performance should return to expected operation. If multiple symptoms overlap, complete the diagnosis before ordering so the replacement targets the true root cause. Inspect surrounding wiring, tubing, and mounting points so the new part is not exposed to the same stress that damaged the old one. After a successful repair, technicians often note the symptom and test result to make future troubleshooting easier. Cleaning the area around the repair helps improve fitment and makes leak or vibration checks more reliable. If multiple symptoms overlap, complete the diagnosis before ordering so the replacement targets the true root cause.