Ice full sensor

Ice Full Sensor is an ice maker replacement part identified by part number 1855501200. It’s intended for service and repair when the original component is worn, damaged, or missing. Use the part number on your machine or old component to confirm you’re ordering the correct item. This sensor feeds temperature information back to the ice maker’s control system so the machine can time the freeze and harvest stages. When a sensor drifts out of range or fails open/short, you may see erratic cycling, premature shutdowns, or inconsistent ice thickness. If you’re troubleshooting a machine that won’t complete freeze/harvest, checking sensor connections and comparing readings to expected conditions is a common first step. Replacing the part can bring the system back to predictable operation and help prevent repeat call-backs. During replacement, disconnect power, handle the sensor lead carefully, and ensure the connector seats fully to prevent intermittent signals. Before closing panels, double-check that fasteners are snug and that nearby lines or wires won’t rub during operation. If the symptom is intermittent, pay close attention to connectors, mounting points, and any signs of vibration-related wear. A careful inspection of adjacent parts can help catch secondary issues that may have contributed to the failure. When possible, run the ice maker long enough to observe at least one complete cycle after the repair. Before closing panels, double-check that fasteners are snug and that nearby lines or wires won’t rub during operation. Before closing panels, double-check that fasteners are snug and that nearby lines or wires won’t rub during operation. Before closing panels, double-check that fasteners are snug and that nearby lines or wires won’t rub during operation.