CAP - JET

Part F660155-03 (Cap Jet) is used when a confirmed fault requires replacing this specific component. It’s a other replacement and is typically sourced after the failed cap jet is confirmed. Match part F660155-03 to the removed cap jet and compare connectors, mounting points, and orientation before ordering. Functionally, it supports normal equipment operation when replaced correctly; when it fails, the machine may not behave normally. Common service complaints for the cap jet include intermittent operation, repeat callbacks, and downtime. Once the fault is isolated to the cap jet, replacement typically resolves the complaint. Good troubleshooting helps prevent repeat returns and unnecessary part swaps. To verify whether the cap jet is at fault, technicians may: inspect surrounding components for damage; verify the symptom under load. Using part F660155-03 after diagnosis fixes the issue at the source instead of masking the symptom. After diagnosis, the last step is a correct replacement and post-repair test. Compare the old cap jet to part F660155-03, install with standard service practices, then verify with a test cycle. Once part F660155-03 is installed and tested, the unit should return to normal performance with fewer intermittent issues. Inspect related components so the new part isn’t exposed to the same stress that damaged the original. Keep the removed part nearby for a quick side-by-side comparison during installation. If the unit has multiple revisions, confirm the exact configuration to avoid mismatched parts. Keep the removed part nearby for a quick side-by-side comparison during installation. Keep the removed part nearby for a quick side-by-side comparison during installation. Document the symptom and the post-repair test result for future service history. Document the symptom and the post-repair test result for future service history. Keep the removed part nearby for a quick side-by-side comparison during installation.