Evaporator (ice mold)

Evaporator Ice Mold is an ice maker replacement part identified by part number 1880024201. It’s intended for service and repair when the original component is worn, damaged, or missing. Use the part number on your machine or old component to confirm you’re ordering the correct item. This replacement component is listed for ice maker service and is ordered by part number to match the correct assembly location. Wear, cracking, corrosion, or looseness can create intermittent problems that show up only during certain parts of the cycle. Technicians typically compare the failed part to the replacement listing and inspect surrounding hardware for related wear or damage. Replacing the part can bring the system back to predictable operation and help prevent repeat call-backs. After installation, run the unit and confirm the original symptom is resolved without introducing new noise or leaks. When possible, run the ice maker long enough to observe at least one complete cycle after the repair. A careful inspection of adjacent parts can help catch secondary issues that may have contributed to the failure. When possible, run the ice maker long enough to observe at least one complete cycle after the repair. If the symptom is intermittent, pay close attention to connectors, mounting points, and any signs of vibration-related wear. If the symptom is intermittent, pay close attention to connectors, mounting points, and any signs of vibration-related wear. When possible, run the ice maker long enough to observe at least one complete cycle after the repair. When possible, run the ice maker long enough to observe at least one complete cycle after the repair. When possible, run the ice maker long enough to observe at least one complete cycle after the repair.