Temperature display film

Temperature Display Film is listed under part number 1864806001 for ice machine replacement and service work. Technicians typically replace this part when they’re seeing noise, visible wear, cracking, or a component that won’t stay seated. After replacement, run at least one full cycle and recheck for leaks, vibration noise, or fasteners that loosen during operation. This replacement component supports normal operation by restoring fit, sealing, alignment, or control behavior. Disconnect power before service. Reinstall carefully so nothing pinches, rubs, or binds once the unit is back together. Replacing the correct part helps restore predictable operation and reduces repeat service calls. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly.