TUBING - PER FT.

A reliable repair often starts with the right part number—13-0674-07 corresponds to Tubing Per Ft. Match the part number and visual configuration before ordering. Small components can create big downtime when they loosen, leak, or interfere with movement. A clean, correctly seated replacement often resolves recurring issues caused by vibration or wear. Technicians may encounter intermittent operation, repeat failure, or intermittent behavior depending on the application. Recheck fasteners and connectors after the first run-in cycle to confirm everything remains tight. Reinstall carefully so nothing pinches, rubs, or binds once the unit is back together. Once the root cause is corrected, cycle behavior should stabilize and performance should return to normal. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Check nearby components for secondary damage so the new part isn’t stressed immediately after installation. Once the underlying cause is addressed, poor fitment complaints usually reduce or disappear. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.