SOLENOID WATER INLET

Solenoid Water Inlet is a practical swap when addressing no fill; order by part number 12-2922-01. Match the part number and visual configuration before ordering. A sticking or leaking valve can cause underfill, overfill, or inconsistent cycles. A sticking or leaking valve can cause underfill, overfill, or inconsistent cycles. Symptoms often show up as no fill and may progress to overfill. Disconnect power before service and document the original routing or hardware positions with a quick photo. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. Using the correct replacement part helps restore steady operation and reduces repeat service calls. Check nearby components for secondary damage so the new part isn’t stressed immediately after installation. Confirm the symptom first, then inspect the part location for wear, corrosion, cracks, or looseness. A new Solenoid Water Inlet often clears overfill issues caused by wear or damage. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.