TRIM STRIP RIGHT SID

Trim Strip Right Sid is a replacement component listed as part 02-4221-02 for ice machines. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved without introducing new leaks or noise. Once the root cause is corrected, performance should stabilize and output should return to normal. This replacement component supports normal operation by restoring fit, sealing, alignment, or control behavior. If the machine is showing leaks, inspect this area for looseness, rubbing marks, mineral buildup, or secondary damage to nearby parts. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and anything that loosens during operation. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period.