WATER HEADER LEFT SI

This replacement component supports normal operation by restoring fit, sealing, alignment, or control behavior. If you’re troubleshooting inconsistent operation on a Multiple brands unit, the Water Header Left Si (part 02-4064-01) is a common replacement item. Depending on installation, failure can present as inconsistent operation, intermittent operation, abnormal noise, or a cycle that won’t complete normally. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and fasteners that loosen during operation. Disconnect power before service. Reassemble so nothing pinches, rubs, or binds once the unit is back together. Once the root cause is corrected, performance should stabilize and output should return to normal. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period.