compressor

If the machine is showing not cooling, inspect this area for looseness, corrosion, rubbing marks, or a part that’s shifted out of position. After replacement, run at least one full cycle and recheck for leaks, vibration noise, or fasteners that loosen during operation. Diagnosing not cooling often leads back to a worn or damaged part—Compressor (part Y320001067) is one of those common service items. The compressor drives the refrigeration cycle. Cooling loss can show up as slow production, long run times, or no ice when the system can’t pull temperature down. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved and nothing else is stressed. Once the root cause is corrected, performance should stabilize and output should return to normal. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period.