additional evaporator

Part L242001180 corresponds to Additional Evaporator and is commonly sourced for ice maker repairs. Evaporator-related components influence freezing and harvest. Wear here can lead to uneven ice, poor release, or low production. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved and nothing else is stressed. A correct-fit replacement can prevent small issues from turning into bigger failures. If the machine is showing ice not releasing, inspect this area for looseness, corrosion, rubbing marks, or a part that’s shifted out of position. After replacement, run at least one full cycle and recheck for leaks, vibration noise, or fasteners that loosen during operation. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period.