lamp holder clip

Brackets and hardware keep assemblies aligned under vibration. Loose mounting leads to noise and repeat failures. Diagnosing loose parts often leads back to a worn or damaged part—Lamp Holder Clip (part L232000106) is one of those common service items. If the machine is showing loose parts, inspect this area for looseness, corrosion, rubbing marks, or a part that’s shifted out of position. After replacement, run at least one full cycle and recheck for leaks, vibration noise, or fasteners that loosen during operation. Disconnect power before service. Reinstall carefully so nothing pinches, rubs, or binds once the unit is back together. Replacing the correct part helps restore predictable operation and reduces repeat service calls. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly.