Ice Chute

Part F660477-01 (Ice Chute) is used when a confirmed fault requires replacing this specific component. It’s a other replacement and is typically sourced after the failed ice chute is confirmed. Verify fitment by part number F660477-01 and physical layout on the unit—small revision changes can matter. Because it supports normal equipment operation when replaced correctly, faults here can create clear, repeatable symptoms. Failures tied to the ice chute can show up as intermittent operation, wear/damage, and repeat callbacks. Because the ice chute influences how the unit runs, symptoms may worsen under normal load. Good troubleshooting helps prevent repeat returns and unnecessary part swaps. To verify whether the ice chute is at fault, technicians may: verify the symptom under load; confirm the part number and fitment. A confirmed swap to part F660477-01 helps reduce repeat downtime and recurring intermittent faults. To complete the repair successfully, focus on fitment and verification. Order part F660477-01, install the ice chute carefully, and run a full operating cycle test after replacement. Replacing the confirmed failed ice chute with part F660477-01 often resolves the complaint and stabilizes operation. If the unit has multiple revisions, confirm the exact configuration to avoid mismatched parts. Document the symptom and the post-repair test result for future service history. If the unit has multiple revisions, confirm the exact configuration to avoid mismatched parts. Inspect related components so the new part isn’t exposed to the same stress that damaged the original. If the unit has multiple revisions, confirm the exact configuration to avoid mismatched parts. Inspect related components so the new part isn’t exposed to the same stress that damaged the original. Document the symptom and the post-repair test result for future service history. Inspect related components so the new part isn’t exposed to the same stress that damaged the original.