CONTROL CUBE SIZE

For technicians ordering by number, part F620264-11 corresponds to the control cube size. Keeping the removed part for comparison until testing is complete can help avoid installation surprises. As a control board, this part is used to restore control logic and outputs that coordinate the machine’s sequence. Symptoms that can point toward this type of part include stuck cycle, random shutdowns, and error code. In repairs, replacement is considered when inspection and testing confirm the fault is tied to this component. Before replacement, technicians typically verify inputs/outputs (or fitment/movement for mechanical parts) so the root cause is confirmed. Control board replacement is normally done after verifying inputs/outputs and confirming external loads or sensors are not causing the fault. Once the failed part is confirmed and replaced, cycle behavior should normalize and performance should return to expected operation. Disconnect power before service, document the original layout with a photo, and reinstall so nothing pinches, rubs, or binds. After installation, run a short test cycle and check for stable operation, leaks, vibration noise, and any recurring fault symptoms. Once the failed part is confirmed and replaced, cycle behavior should normalize and performance should return to expected operation. If multiple symptoms overlap, complete the diagnosis before ordering so the replacement targets the true root cause. Inspect surrounding wiring, tubing, and mounting points so the new part is not exposed to the same stress that damaged the old one. After a successful repair, technicians often note the symptom and test result to make future troubleshooting easier. Cleaning the area around the repair helps improve fitment and makes leak or vibration checks more reliable. If multiple symptoms overlap, complete the diagnosis before ordering so the replacement targets the true root cause.