Comp. Relay 230/50/6

The comp relay 230506 (part F620057-45) is typically replaced when wear or damage affects normal operation. Before ordering, compare the removed component to the listing photos and confirm connector style, mounting points, and orientation. As a relay/contactor, this part is used to restore switching in the start/run circuit for a load. Symptoms that can point toward this type of part include clicking but not starting, voltage drop, and compressor not engaging. Once the failure is confirmed, replacing the part helps correct the specific fault path and stabilize operation. Good troubleshooting includes matching the part number, checking the installation area, and confirming the failure is not caused by a related component. Relays/contactors are usually checked for coil continuity, contact wear, and terminal heat marks that can cause voltage drop or chatter. Once the failed part is confirmed and replaced, cycle behavior should normalize and performance should return to expected operation. Disconnect power before service, document the original layout with a photo, and reinstall so nothing pinches, rubs, or binds. After installation, run a short test cycle and check for stable operation, leaks, vibration noise, and any recurring fault symptoms. Replacing the correct component helps restore predictable operation and reduces repeat service calls when the diagnosis is accurate. If multiple symptoms overlap, complete the diagnosis before ordering so the replacement targets the true root cause. Inspect surrounding wiring, tubing, and mounting points so the new part is not exposed to the same stress that damaged the old one. After a successful repair, technicians often note the symptom and test result to make future troubleshooting easier. Cleaning the area around the repair helps improve fitment and makes leak or vibration checks more reliable. If multiple symptoms overlap, complete the diagnosis before ordering so the replacement targets the true root cause.