Thrust Washer

This component—thrust washer, part F440013-06—is ordered when symptoms point to a failure in this area. A correct part-number match matters because similar-looking parts can have different connectors, ratings, or mounting details. As a seal/gasket, this part is used to restore sealing at joints and fittings to prevent leaks and air gaps. Common complaints tied to this category include moisture intrusion, leaks, and air gap. Technicians often replace this component after confirming drips, moisture intrusion, or poor sealing. Before replacement, technicians typically verify inputs/outputs (or fitment/movement for mechanical parts) so the root cause is confirmed. Seals and gaskets are replaced when compression set, tears, or hardening create a leak path at the mating surfaces. Once the failed part is confirmed and replaced, cycle behavior should normalize and performance should return to expected operation. Disconnect power before service, document the original layout with a photo, and reinstall so nothing pinches, rubs, or binds. Disconnect power before service, document the original layout with a photo, and reinstall so nothing pinches, rubs, or binds. A correct-fit replacement can prevent small issues from turning into bigger failures and helps stabilize machine performance. If multiple symptoms overlap, complete the diagnosis before ordering so the replacement targets the true root cause. Inspect surrounding wiring, tubing, and mounting points so the new part is not exposed to the same stress that damaged the old one. After a successful repair, technicians often note the symptom and test result to make future troubleshooting easier. Cleaning the area around the repair helps improve fitment and makes leak or vibration checks more reliable. If multiple symptoms overlap, complete the diagnosis before ordering so the replacement targets the true root cause. Inspect surrounding wiring, tubing, and mounting points so the new part is not exposed to the same stress that damaged the old one.