Sweep Arm - Part obsolete, USE A36846-002

For technicians ordering by number, part B3002310304 corresponds to the sweep arm part obsolete use a36846 002. Before ordering, compare the removed component to the listing photos and confirm connector style, mounting points, and orientation. The naming indicates a supersession; use A36846-002 when that replacement is specified for your unit. Identifiers like A36846 appear in the naming; verify them against the equipment data plate. As a other, this part is used to restore general replacement support in a repair scenario. Common complaints tied to this category include intermittent operation, repeat callback, and worn component. Once the failure is confirmed, replacing the part helps correct the specific fault path and stabilize operation. A practical diagnostic path is to confirm the symptom, then test the related circuit or assembly and inspect nearby components for secondary damage. For general parts, verify fitment and test the associated function so the replacement targets the true root cause. Once the failed part is confirmed and replaced, cycle behavior should normalize and performance should return to expected operation. If the part is in a water path, do a leak check during the first run and again after the unit has operated for a short period. After installation, run a short test cycle and check for stable operation, leaks, vibration noise, and any recurring fault symptoms. Once the failed part is confirmed and replaced, cycle behavior should normalize and performance should return to expected operation. If multiple symptoms overlap, complete the diagnosis before ordering so the replacement targets the true root cause. Inspect surrounding wiring, tubing, and mounting points so the new part is not exposed to the same stress that damaged the old one. After a successful repair, technicians often note the symptom and test result to make future troubleshooting easier.