Sink Gray - Part obsolete, USE 02-4013-01

Technicians ordering part A36851-002 are typically replacing the sink gray part obsolete use 02 4013 01 in an ice machine system. Replacement is usually considered after inspection confirms wear, damage, electrical failure, or a repeat operating issue tied to this component. Brand compatibility should be matched to the exact machine nameplate and part number before ordering. Model verification is important because close machine variants may use different revisions of the same component category. Supports replacement and repair work when the original component is worn, damaged, or no longer functioning correctly. A failing part in this category may cause symptoms like worn component replacement, maintenance replacement, and fitment repair. The exact symptom pattern depends on where the component is used, which is why part-number matching and complaint-based diagnosis matter. For this other category, the typical repair goal is to restore the function that the failed component was affecting. In troubleshooting, matching the part number and checking the related wiring, mounting points, and operating conditions helps avoid repeat repairs. A correct part-number match is especially important on general components, since the same machine family may use different revisions. A quick inspection of wiring, connectors, mounting hardware, and surrounding components can prevent a repeat failure after replacement. Installing the correct replacement part can resolve the targeted fault path and helps bring the machine back to stable operation when the diagnosis is accurate. For ordering, match the part number exactly and compare the removed component to the replacement before installation. That step matters on commercial ice equipment because similar-looking parts can have different ratings, connectors, or mounting details. If you are troubleshooting symptoms such as not turning on, no power, not cooling, not starting, intermittent operation, error code behavior, or ice not dropping, confirming the failed component first will make this replacement more effective.