Rod that holds the flakes

Rod That Holds the Flakes is listed under part number 1861704900 for ice machine replacement and service work. This replacement component supports normal operation by restoring fit, sealing, alignment, or control behavior. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved and nothing else is stressed. A correct-fit replacement can prevent small issues from turning into bigger failures. Technicians typically replace this part when they’re seeing leaks, visible wear, cracking, or a component that won’t stay seated. After replacement, run at least one full cycle and recheck for leaks, vibration noise, or fasteners that loosen during operation. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly.