Main control panel (FIM200)

Main Control Panel FIM200 is listed under part number 1854205901 for ice machine replacement and service work. The listing name references model(s) FIM200. Control components coordinate sequence and timing across the machine. When they fail, you can see no-start conditions, erratic cycling, or components that never energize. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved and nothing else is stressed. Once the root cause is corrected, performance should stabilize and output should return to normal. If the machine is showing erratic cycling, inspect this area for looseness, corrosion, rubbing marks, or a part that’s shifted out of position. If the problem changes with vibration or after moving panels, look for borderline fitment and loose connectors in the same area. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly.