FAN MOTOR

The fan motor identified as part 18-8796-01 is a replacement component used during equipment repairs. Replacement is usually considered after inspection confirms wear, damage, electrical failure, or a repeat operating issue tied to this component. Brand compatibility should be matched to the exact machine nameplate and part number before ordering. Where model references are available, cross-check the service model and revision level because similar machines can use different parts. Restores fan, drive, or mechanical movement when airflow or rotation is weak, noisy, or completely stopped. Common service symptoms that can point toward this type of part include fan not spinning, motor not starting, and low airflow. Motor failures may cause stopped airflow, weak movement, unusual noise, or intermittent rotation that affects machine operation. For this motor category, the typical repair goal is to restore the function that the failed component was affecting. During diagnosis, the part number should be matched first, then the circuit or assembly should be tested to confirm the failure path. For motor service calls, it helps to confirm proper voltage and check for seized shafts, worn bearings, or damaged wiring at the motor leads. A quick inspection of wiring, connectors, mounting hardware, and surrounding components can prevent a repeat failure after replacement. Once the failed part is confirmed, replacing it with the correct item can restore normal function and prevent ongoing intermittent complaints. For ordering, match the part number exactly and compare the removed component to the replacement before installation. That step matters on commercial ice equipment because similar-looking parts can have different ratings, connectors, or mounting details. If you are troubleshooting symptoms such as not turning on, no power, not cooling, not starting, intermittent operation, error code behavior, or ice not dropping, confirming the failed component first will make this replacement more effective.