LABEL ICE - GREY

When a unit shows worn part issues, the Label Ice Grey is often evaluated; part 17-2288-04 is the replacement reference. Match the part number and visual configuration before ordering. If the issue is intermittent, look for vibration-related wear marks and connectors that shift under load. Confirm the symptom first, then inspect the part location for wear, corrosion, cracks, or looseness. Replacing Label Ice Grey can resolve repeat failure when the fault is confirmed at this component. Disconnect power before service and document the original routing or hardware positions with a quick photo. Recheck fasteners and connectors after the first run-in cycle to confirm everything remains tight. Once the root cause is corrected, cycle behavior should stabilize and performance should return to normal. Technicians often replace this part after finding wear, cracking, or a poor fit during inspection. Small components can create big downtime when they loosen, leak, or interfere with movement. Technicians may encounter repeat failure, worn part issues, or intermittent behavior depending on the application. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed.