WATER INLET FITTING

Service replacement: 16-1198-01 Water Inlet Fitting, commonly ordered by repair technicians. Match the part number and visual configuration before ordering. Check nearby components for secondary damage so the new part isn’t stressed immediately after installation. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Once the underlying cause is addressed, restricted flow complaints usually reduce or disappear. Drain and line components route water correctly and help prevent leaks at connections. Cracks, kinks, or loose fittings can create messy symptoms that look worse than the part itself. Technicians may encounter drips, poor drainage, or intermittent behavior depending on the application. Reinstall carefully so nothing pinches, rubs, or binds once the unit is back together. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. Using the correct replacement part helps restore steady operation and reduces repeat service calls. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.