TXV 1/2 TON ALCO

Start with the identifier: part 16-1117-02 is the Txv 12 Ton Alco replacement used during ice machine service. Order by part number to avoid mismatches. This replacement component supports normal operation when the original part can’t be reused. Technicians often replace this part after finding wear, cracking, or a poor fit during inspection. Technicians may encounter intermittent operation, repeat failure, or intermittent behavior depending on the application. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. Disconnect power before service and document the original routing or hardware positions with a quick photo. A correct-fit part improves reliability and prevents small issues from becoming bigger failures. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. If the issue is intermittent, look for vibration-related wear marks and connectors that shift under load. Once the underlying cause is addressed, worn part issues complaints usually reduce or disappear. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed.