HEADER - HOT GAS

Part 16-1106-01 (Header Hot Gas) is a service replacement for ice machine repairs. Match the part number and visual configuration before ordering. Technicians often replace this part after finding wear, cracking, or a poor fit during inspection. This replacement component supports normal operation when the original part can’t be reused. Common complaints include poor fitment, downtime, or intermittent operation. Disconnect power before service and document the original routing or hardware positions with a quick photo. Recheck fasteners and connectors after the first run-in cycle to confirm everything remains tight. Using the correct replacement part helps restore steady operation and reduces repeat service calls. Check nearby components for secondary damage so the new part isn’t stressed immediately after installation. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Once the underlying cause is addressed, intermittent operation complaints usually reduce or disappear. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.