ADPTER - BARBED

Chasing repeat failure? The Adpter Barbed can be the culprit; part 16-1099-01 is the service replacement. Use the part number as the primary identifier when ordering. Check nearby components for secondary damage so the new part isn’t stressed immediately after installation. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Once the underlying cause is addressed, downtime complaints usually reduce or disappear. Recheck fasteners and connectors after the first run-in cycle to confirm everything remains tight. Reinstall carefully so nothing pinches, rubs, or binds once the unit is back together. Once the root cause is corrected, cycle behavior should stabilize and performance should return to normal. Technicians often replace this part after finding wear, cracking, or a poor fit during inspection. This replacement component supports normal operation when the original part can’t be reused. Technicians may encounter repeat failure, intermittent operation, or intermittent behavior depending on the application. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.