STRAINER 1/4

Part 16-1063-02 is the part number for the Strainer 14, sourced by technicians to avoid mismatched revisions. It’s used in service work when the strainer 14 is worn, damaged, or no longer performing correctly. Verify fitment by part number 16-1063-02 and physical layout on the unit—small revision changes can matter. What it does: it supports normal equipment operation when replaced correctly. When this other starts to fail, you may see wear/damage, downtime, and repeat callbacks. Once the fault is isolated to the strainer 14, replacement typically resolves the complaint. Technicians typically verify the fault before ordering the replacement. To verify whether the strainer 14 is at fault, technicians may: replace only after isolating the root cause; verify the symptom under load. After confirmation, replacing the strainer 14 with part 16-1063-02 restores the affected function and stabilizes operation. To complete the repair successfully, focus on fitment and verification. Compare the old strainer 14 to part 16-1063-02, install with standard service practices, then verify with a test cycle. A verified part-number match for 16-1063-02 plus proper installation is the fastest route back to reliable operation. Inspect related components so the new part isn’t exposed to the same stress that damaged the original. If the unit has multiple revisions, confirm the exact configuration to avoid mismatched parts. If the unit has multiple revisions, confirm the exact configuration to avoid mismatched parts. Inspect related components so the new part isn’t exposed to the same stress that damaged the original. Keep the removed part nearby for a quick side-by-side comparison during installation. Keep the removed part nearby for a quick side-by-side comparison during installation. Keep the removed part nearby for a quick side-by-side comparison during installation. Keep the removed part nearby for a quick side-by-side comparison during installation.