DISTRIBUTOR and TUBES

Distributor and Tubes is a practical swap when addressing water leak; order by part number 16-0876-01. Match the part number and visual configuration before ordering. Confirm the symptom first, then inspect the part location for wear, corrosion, cracks, or looseness. Check nearby components for secondary damage so the new part isn’t stressed immediately after installation. Replacing Distributor and Tubes can resolve water leak when the fault is confirmed at this component. Drain and line components route water correctly and help prevent leaks at connections. Cracks, kinks, or loose fittings can create messy symptoms that look worse than the part itself. Symptoms often show up as water leak and may progress to poor drainage. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. Reinstall carefully so nothing pinches, rubs, or binds once the unit is back together. Once the root cause is corrected, cycle behavior should stabilize and performance should return to normal. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed.