Valve - Part obsolete, USE 16-0816-22

When a unit shows leaking, the Valve Part Obsolete use 16 0816 22 is often evaluated; part 16-0816-02 is the replacement reference. (Note: listing shows obsolete; use 16-0816-22 when applicable.) Order by part number to avoid mismatches. Valves regulate water flow and timing during fill events. A sticking or leaking valve can cause underfill, overfill, or inconsistent cycles. Common complaints include overfill, leaking, or intermittent feed. If the issue is intermittent, look for vibration-related wear marks and connectors that shift under load. Confirm the symptom first, then inspect the part location for wear, corrosion, cracks, or looseness. Once the underlying cause is addressed, intermittent feed complaints usually reduce or disappear. Recheck fasteners and connectors after the first run-in cycle to confirm everything remains tight. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. Using the correct replacement part helps restore steady operation and reduces repeat service calls. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.