Valve Expansion - Part obsolete, USE 16-0758-23

Replace the failed Valve Expansion Part Obsolete use 16 0758 23 with part 16-0758-03 after confirming the symptom and fitment. (Note: listing shows obsolete; use 16-0758-23 when applicable.) Use the part number as the primary identifier when ordering. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. Disconnect power before service and document the original routing or hardware positions with a quick photo. Using the correct replacement part helps restore steady operation and reduces repeat service calls. A sticking or leaking valve can cause underfill, overfill, or inconsistent cycles. A sticking or leaking valve can cause underfill, overfill, or inconsistent cycles. Technicians may encounter leaking, intermittent feed, or intermittent behavior depending on the application. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Once the underlying cause is addressed, low flow complaints usually reduce or disappear. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed.