Label - Part obsolete, USE 15-0680-03

If you’re ordering for a service job, Label Part Obsolete use 15 0680 03 is supplied as part 15-0680-02. (Note: listing shows obsolete; use 15-0680-03 when applicable.) Use the part number as the primary identifier when ordering. Small components can create big downtime when they loosen, leak, or interfere with movement. This replacement component supports normal operation when the original part can’t be reused. Symptoms often show up as repeat failure and may progress to poor fitment. If the issue is intermittent, look for vibration-related wear marks and connectors that shift under load. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Replacing Label Part Obsolete use 15 0680 03 can resolve repeat failure when the fault is confirmed at this component. Reinstall carefully so nothing pinches, rubs, or binds once the unit is back together. Disconnect power before service and document the original routing or hardware positions with a quick photo. Once the root cause is corrected, cycle behavior should stabilize and performance should return to normal. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order.