RUBBER BUMPER

When a unit shows downtime, the Rubber Bumper is often evaluated; part 13-0616-00 is the replacement reference. Match the part number and visual configuration before ordering. Small components can create big downtime when they loosen, leak, or interfere with movement. A clean, correctly seated replacement often resolves recurring issues caused by vibration or wear. Technicians may encounter repeat failure, downtime, or intermittent behavior depending on the application. If the issue is intermittent, look for vibration-related wear marks and connectors that shift under load. Confirm the symptom first, then inspect the part location for wear, corrosion, cracks, or looseness. Replacing Rubber Bumper can resolve repeat failure when the fault is confirmed at this component. Recheck fasteners and connectors after the first run-in cycle to confirm everything remains tight. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. Using the correct replacement part helps restore steady operation and reduces repeat service calls. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.