Tubing Closed

Chasing poor fitment? The Tubing Closed can be the culprit; part 13-0228-00 is the service replacement. Match the part number and visual configuration before ordering. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. A new Tubing Closed often clears repeat failure issues caused by wear or damage. This replacement component supports normal operation when the original part can’t be reused. Replacing a worn component early can prevent secondary damage to nearby parts. Technicians may encounter poor fitment, repeat failure, or intermittent behavior depending on the application. Recheck fasteners and connectors after the first run-in cycle to confirm everything remains tight. Reinstall carefully so nothing pinches, rubs, or binds once the unit is back together. Once the root cause is corrected, cycle behavior should stabilize and performance should return to normal. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.