Grommet

Troubleshooting tip: confirm worn part issues first, then check Grommet; use part 13-0116-00 if replacement is needed. Use the part number as the primary identifier when ordering. A correct-fit replacement helps restore predictable performance and reduces repeat callbacks. Technicians often replace this part after finding wear, cracking, or a poor fit during inspection. Symptoms often show up as worn part issues and may progress to intermittent operation. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. If the issue is intermittent, look for vibration-related wear marks and connectors that shift under load. Replacing Grommet can resolve worn part issues when the fault is confirmed at this component. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. Disconnect power before service and document the original routing or hardware positions with a quick photo. Once the root cause is corrected, cycle behavior should stabilize and performance should return to normal. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed.