LOCK and KEY

Part 12-2896-26 (Lock and Key) is a service replacement for ice machine repairs. Use the part number as the primary identifier when ordering. Check nearby components for secondary damage so the new part isn’t stressed immediately after installation. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Once the underlying cause is addressed, repeat failure complaints usually reduce or disappear. Reinstall carefully so nothing pinches, rubs, or binds once the unit is back together. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. A correct-fit part improves reliability and prevents small issues from becoming bigger failures. Technicians often replace this part after finding wear, cracking, or a poor fit during inspection. Small components can create big downtime when they loosen, leak, or interfere with movement. Common complaints include downtime, poor fitment, or repeat failure. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.