HOT GAS VALVE-COIL 2

Part 12-2719-23 is the replacement listing for Hot Gas Valve Coil 2, used in routine ice machine maintenance. Use the part number as the primary identifier when ordering. Supply pressure and inlet restrictions should be checked alongside the valve. A sticking or leaking valve can cause underfill, overfill, or inconsistent cycles. Technicians may encounter intermittent feed, low flow, or intermittent behavior depending on the application. Recheck fasteners and connectors after the first run-in cycle to confirm everything remains tight. Reinstall carefully so nothing pinches, rubs, or binds once the unit is back together. Once the root cause is corrected, cycle behavior should stabilize and performance should return to normal. If the issue is intermittent, look for vibration-related wear marks and connectors that shift under load. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Once the underlying cause is addressed, no fill complaints usually reduce or disappear. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.