CONTACTOR

If your machine shows repeat failure, the Contactor is one of the parts commonly checked; part 12-2595-01 is the replacement listing. Order by part number to avoid mismatches. This replacement component supports normal operation when the original part can’t be reused. A correct-fit replacement helps restore predictable performance and reduces repeat callbacks. Symptoms often show up as repeat failure and may progress to worn part issues. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Once the underlying cause is addressed, intermittent operation complaints usually reduce or disappear. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. Recheck fasteners and connectors after the first run-in cycle to confirm everything remains tight. Using the correct replacement part helps restore steady operation and reduces repeat service calls. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.