Hot Gas Valve - Part obsolete, USE 12-2471-03

Hot Gas Valve Part Obsolete use 12 2471 03 is a practical swap when addressing no fill; order by part number 12-2471-23. (Note: listing shows obsolete; use 12-2471-03 when applicable.) Order by part number to avoid mismatches. A sticking or leaking valve can cause underfill, overfill, or inconsistent cycles. Supply pressure and inlet restrictions should be checked alongside the valve. Common complaints include no fill, overfill, or low flow. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Once the underlying cause is addressed, low flow complaints usually reduce or disappear. Recheck fasteners and connectors after the first run-in cycle to confirm everything remains tight. Disconnect power before service and document the original routing or hardware positions with a quick photo. A correct-fit part improves reliability and prevents small issues from becoming bigger failures. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed.