Hot Gas Valve - Part obsolete, USE 12-2471-01

For a straightforward replacement, match Hot Gas Valve Part Obsolete use 12 2471 01 to part 12-2471-21 before ordering. (Note: listing shows obsolete; use 12-2471-01 when applicable.) Order by part number to avoid mismatches. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. If the issue is intermittent, look for vibration-related wear marks and connectors that shift under load. Once the underlying cause is addressed, leaking complaints usually reduce or disappear. Valves regulate water flow and timing during fill events. A sticking or leaking valve can cause underfill, overfill, or inconsistent cycles. Symptoms often show up as no fill and may progress to intermittent feed. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. Recheck fasteners and connectors after the first run-in cycle to confirm everything remains tight. A correct-fit part improves reliability and prevents small issues from becoming bigger failures. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.