Solenoid Valve - Part obsolete, USE 12-2446-23

Start with the identifier: part 12-2446-03 is the Solenoid Valve Part Obsolete use 12 2446 23 replacement used during ice machine service. (Note: listing shows obsolete; use 12-2446-23 when applicable.) Order by part number to avoid mismatches. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Check nearby components for secondary damage so the new part isn’t stressed immediately after installation. A new Solenoid Valve Part Obsolete use 12 2446 23 often clears intermittent feed issues caused by wear or damage. Supply pressure and inlet restrictions should be checked alongside the valve. Supply pressure and inlet restrictions should be checked alongside the valve. Technicians may encounter overfill, intermittent feed, or intermittent behavior depending on the application. Recheck fasteners and connectors after the first run-in cycle to confirm everything remains tight. Disconnect power before service and document the original routing or hardware positions with a quick photo. A correct-fit part improves reliability and prevents small issues from becoming bigger failures. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed.