WATER SOLENOID

Start with the identifier: part 12-2313-04 is the Water Solenoid replacement used during ice machine service. Order by part number to avoid mismatches. A sticking or leaking valve can cause underfill, overfill, or inconsistent cycles. Supply pressure and inlet restrictions should be checked alongside the valve. Symptoms often show up as leaking and may progress to low flow. If the issue is intermittent, look for vibration-related wear marks and connectors that shift under load. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Replacing Water Solenoid can resolve leaking when the fault is confirmed at this component. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. Reinstall carefully so nothing pinches, rubs, or binds once the unit is back together. Once the root cause is corrected, cycle behavior should stabilize and performance should return to normal. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.