Valve Inlet - Part obsolete, USE 12-2313-03

Chasing leaking? The Valve Inlet Part Obsolete use 12 2313 03 can be the culprit; part 12-2261-03 is the service replacement. (Note: listing shows obsolete; use 12-2313-03 when applicable.) Match the part number and visual configuration before ordering. A sticking or leaking valve can cause underfill, overfill, or inconsistent cycles. Valves regulate water flow and timing during fill events. Common complaints include leaking, overfill, or no fill. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Once the underlying cause is addressed, no fill complaints usually reduce or disappear. Reinstall carefully so nothing pinches, rubs, or binds once the unit is back together. Disconnect power before service and document the original routing or hardware positions with a quick photo. Using the correct replacement part helps restore steady operation and reduces repeat service calls. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair.