Valve-inlet - Part obsolete, USE 12-2313-02

Troubleshooting tip: confirm low flow first, then check Valve Inlet Part Obsolete use 12 2313 02; use part 12-2261-02 if replacement is needed. (Note: listing shows obsolete; use 12-2313-02 when applicable.) Use the part number as the primary identifier when ordering. Supply pressure and inlet restrictions should be checked alongside the valve. A sticking or leaking valve can cause underfill, overfill, or inconsistent cycles. Technicians may encounter low flow, overfill, or intermittent behavior depending on the application. Confirm the symptom first, then inspect the part location for wear, corrosion, cracks, or looseness. Compare the old part to the replacement, paying attention to connector orientation, mounting points, and sealing surfaces. Once the underlying cause is addressed, no fill complaints usually reduce or disappear. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. After replacement, run a short test cycle and watch for leaks, vibration noise, or recurring faults. A correct-fit part improves reliability and prevents small issues from becoming bigger failures. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed. If the machine was down for a while, take the opportunity to clean the area around the repair. Verify any model compatibility notes shown on the product page before completing the order. Keep the removed part until final testing is complete so you can compare fitment if needed.