Fastener Package

Even simple parts can cause major downtime when they loosen, leak, or interfere with movement. For technicians troubleshooting inconsistent operation, Fastener Package is a part that’s often inspected and replaced when failure is confirmed (part 03-3815-02). Symptoms can present as inconsistent operation, intermittent operation, abnormal noise, or a cycle that won’t complete normally—depending on where this part sits in the system. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and anything that loosens during operation. Use part number 03-3815-02 as the primary identifier, compare the replacement to the original, and install with careful alignment and routing. Once the root cause is corrected, performance should stabilize and output should return to normal. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period.