Screw

Hardware wear is often visible: elongated holes, stripped threads, or parts that won’t stay tight. Use part number 03-3814-01 when ordering Screw for a repair—especially when the symptom points to this section of the machine. If the machine is showing fasteners not holding, inspect this area for looseness, rubbing marks, mineral buildup, or secondary damage to nearby parts. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and anything that loosens during operation. Use part number 03-3814-01 as the primary identifier, compare the replacement to the original, and install with careful alignment and routing. Replacing a worn part early can prevent secondary damage to nearby components. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period.