SCREW

Brackets, gussets, clamps, and fasteners keep assemblies aligned under vibration. Loose mounting leads to noise and repeat failures. Replace this part when you see loose parts, visible damage, cracks, corrosion, stripped fasteners, or a component that won’t stay seated. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and anything that loosens during operation. Screw is sold under part number 03-3813-01 for ice maker service and maintenance work. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved without introducing new leaks or noise. Once the root cause is corrected, performance should stabilize and output should return to normal. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly.