RUBBER PAD

Rubber Pad is a replacement component listed as part 03-1729-03 for ice machines. Replace this part when you see wear, visible damage, cracks, corrosion, stripped fasteners, or a component that won’t stay seated. After replacement, run at least one full cycle and recheck for leaks, vibration noise, and anything that loosens during operation. This replacement component supports normal operation by restoring fit, sealing, alignment, or control behavior. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved without introducing new leaks or noise. Once the root cause is corrected, performance should stabilize and output should return to normal. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly.