SCREW

Screw is listed as part 03-1544-04 for ice machine replacement and service work. Brackets, gussets, clamps, and fasteners keep assemblies aligned under vibration. Loose mounting leads to noise and repeat failures. Disconnect power before service. Reinstall so nothing pinches, rubs, or binds once the unit is back together. Once the root cause is corrected, performance should stabilize and output should return to normal. Replace this part when you see loose parts, visible damage, cracks, corrosion, stripped fasteners, or a component that won’t stay seated. If the fault changes with vibration or after moving panels, look for borderline fitment, loose connectors, or wear marks around the installation area. If the part interacts with water, do a leak check during the first run and again after a short operating period. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly.