GASKET

For technicians troubleshooting wet-floor complaints, Gasket is a part that’s often inspected and replaced when failure is confirmed (part 03-1505-00). If the machine is showing wet-floor complaints, inspect this area for looseness, rubbing marks, mineral buildup, or secondary damage to nearby parts. If the fault changes with vibration or after moving panels, look for borderline fitment, loose connectors, or wear marks around the installation area. Seals, gaskets, and washers prevent leaks at joints and interfaces. Once compressed or torn, drips often return even after re-tightening. A short post-repair check—visual inspection plus a full cycle—helps confirm the issue is resolved without introducing new leaks or noise. Replacing a worn part early can prevent secondary damage to nearby components. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. If the part interacts with water, do a leak check during the first run and again after a short operating period. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Recheck fasteners after a short run-in period; vibration can loosen hardware if it isn’t seated correctly. Take a photo before disassembly so you can confirm orientation and fastener locations during reassembly. Clean the area around the repair so debris doesn’t interfere with fitment or sealing surfaces.